Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81150
1.INSTALL HEADLIGHT ASSEMBLY LH
| *A | w/ Headlight Leveling |
Connect each connector and 2 wire harness clamps.
|
Connect the Seat of the Screw. |
Push the headlight assembly LH backward and connect the bracket to the seat of the screw.
Be careful not to break the bracket.
Install the 3 screws and bolt.
52119A
2.INSTALL FRONT BUMPER COVER (for Steel Type Bumper)
53117C
3.INSTALL NO. 1 RADIATOR GRILLE RETAINER (for Steel Type Bumper)
4.INSTALL FRONT BUMPER COVER (for Resin Type Bumper)
5.ADJUST HEADLIGHT AIMING
6.ADJUST FOG LIGHT AIMING (w/ Fog Light)