Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT BULB
RM3250E _59 Vehicle Exterior _038067 LIGHTING (EXT) _0186324 FOG LIGHT BULB A

LIGHTING (EXT)  FOG LIGHT BULB  REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 53892G 1.REMOVE FRONT FENDER SPLASH SHIELD FRONT SEAL LH (for Steel Type Bumper)

Hide 2.DISCONNECT FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (for Resin Type Bumper)

a.
E316906

for 4WD and Pre-Runner:

Remove the 2 clips.


b.
E320981C01
1.219,2.229 1.531,2.427 0.313,0.198 10 false *a
*a 90°
V113147

Turn in this Direction


Turn the pin hold clip 90° and then pull the pin hold clip to remove it.


c.
E316904

Remove the 3 screws and 4 clips and disconnect the front fender splash shield sub-assembly LH.


Hide 81210B 3.REMOVE FOG LIGHT BULB

a.
E316905

Disconnect the connector.


b.
E316902C01
1.74,0.948 2.625,0.948 true 0.552,3.25 1.438,3.25 true 2.677,0.833 2.917,1.01 0.24,0.177 10 true *a 0.365,3.146 0.552,3.323 0.188,0.177 10 true *b
*a Matchmark
*b Unlock Position Mark
V113147

Counterclockwise


Turn the fog light bulb counterclockwise until the matchmark is aligned with the unlock position mark to remove the bulb.

NOTICE:

Do not touch the glass part of the fog light bulb.



Hide 81210B 4.INSTALL FOG LIGHT BULB

a.
E316903C01
0.833,2.115 1.635,0.979 true 0.375,0.771 1.438,0.771 true 1.74,3.135 2.521,2.583 true 0.729,2.156 1.042,2.313 0.313,0.156 10 false *a 0.188,0.677 0.375,0.875 0.188,0.198 10 true *b 2.552,2.479 2.865,2.635 0.313,0.156 10 true *c
*a Matchmark
*b Unlock Position Mark
*c Lock Position Mark
V113147

Clockwise


Align the matchmark of the fog light bulb with the unlock position mark, and then rotate the fog light bulb clockwise until the lock position mark to install the fog light bulb.


Hide 53892G 5.INSTALL FRONT FENDER SPLASH SHIELD FRONT SEAL LH (for Steel Type Bumper)

Hide 6.CONNECT FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (for Resin Type Bumper)

a.

Return the front fender splash shield sub-assembly LH to its original position and install the 3 screws and 4 clips.


b.
E320982C01
1.208,2.208 1.521,2.365 0.313,0.156 10 false *a
*a 90°
V113147

Turn in this Direction


Insert and turn the pin hold clip 90° to install it.


c.

for 4WD and Pre-Runner:

Install the 2 clips.