Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM3250E _59 Vehicle Exterior _038077 DOOR / HATCH _0186364 HOOD A

DOOR / HATCH  HOOD  REASSEMBLY  


PROCEDURE

Hide 1.CONNECT WASHER HOSE

a.
B404412

Attach the clamp to connect the washer hose.


Hide 85035 2.INSTALL WASHER NOZZLE SUB-ASSEMBLY

Hide 76183 3.INSTALL NO. 1 HOOD BULGE PROTECTOR (w/ Hood Bulge)

a.

Clean the No. 1 hood bulge protector installation surface with a non-residue solvent.


b.

Apply primer to the No. 1 hood bulge protector installation area on the hood bulge.

NOTICE:

Apply primer evenly so that there are no uncoated areas.



c.

Remove the peeling paper on a new No. 1 hood bulge protector while making sure not to touch the adhesional surface.


d.
B409002C02
1.865,0.281 2.021,0.479 0.156,0.198 10 false A
A 0 to 2.0 mm


Install a new No. 1 hood bulge protector to the hood bulge.


e.

Remove the peeling paper from double-sided tape and press the double-sided tape to the side of the hood bulge.


f.

Install a new No. 1 hood bulge protector in the position shown in the illustration.

NOTICE:
·

Press the double-sided tape on the No. 1 hood bulge protector firmly to attach.

·

After the primer dries (3 minutes or more), install the No. 1 hood bulge protector.

·

After applying primer, reapply primer after 24 hours elapse.




Hide 76181 4.INSTALL HOOD BULGE (w/ Hood Bulge)

a.
B409001

Attach the clip to install the hood bulge with the 11 nuts.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 76186 5.INSTALL HOOD AIR INTAKE SEAL (w/ Hood Bulge)

a.
B409000

Attach the clip to install the hood air intake seal.


Hide 53341B 6.INSTALL HOOD INSULATOR

a.
B408999

w/ Hood Bulge:

Attach the guide to install the hood insulator with 10 new clips.


b.
B404411

w/ Hood Insulator:

Attach the guide to install the hood insulator with 12 new clips.


Hide 53381 7.INSTALL HOOD TO RADIATOR SUPPORT SEAL

a.
B404410

Install the hood to radiator support seal with the 6 clips.


Hide 75770 8.INSTALL FRONT HOOD MOULDING ASSEMBLY

Hide 75777E 9.INSTALL FRONT HOOD MOULDING PAD

Hide 85035 10.INSPECT WASHER NOZZLE SUB-ASSEMBLY

Hide 85035 11.ADJUST WASHER NOZZLE SUB-ASSEMBLY