This DTC is stored when the headlight leveling ECU assembly detects a malfunction in the rear height control sensor sub-assembly LH power source or rear height control sensor sub-assembly LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2416 | Height Control Sensor Malfunction | ·
Malfunction in rear height control sensor sub-assembly LH ·
Open or short in rear height control sensor sub-assembly LH power source circuit |
·
Rear height control sensor sub-assembly LH ·
Harness or connector ·
Headlight leveling ECU assembly |
If the headlight leveling ECU assembly has been replaced, it is necessary to initialize the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
If any of the following are performed, it is necessary to initialize the headlight leveling ECU assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION
Replacement of the rear height control sensor sub-assembly LH
Removal/installation of the rear height control sensor sub-assembly LH
Work that changes the vehicle height such as replacement of suspension components
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>DTC CHECK / CLEAR
DTC B2416 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Data List.
Read the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Height Sens Pw Supply Val | Height control sensor power supply value | 0.00 to 5.00 V | 4.61 to 5.00 V | - |
| Tester Display |
|---|
| Height Sens Pw Supply Val |
Normal condition listed above is displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G80 headlight leveling ECU assembly connector.
Disconnect the O7 rear height control sensor sub-assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G80-12 (SBR) - O7-3 (SHB) | Always | Below 1 Ω |
| G80-21 (SGR) - O7-1 (SHG) | Always | Below 1 Ω |
| G80-12 (SBR) - Body ground | Always | 10 kΩ or higher |
| G80-21 (SGR) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear height control sensor sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL
Inspect the rear height control sensor sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG