Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing.
2.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45100
4.REMOVE STEERING WHEEL ASSEMBLY
45287
5.REMOVE STEERING COLUMN LOWER COVER
Remove the 3 bolts.
|
Place Hands Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the 2 claws and 6 guides to remove the steering column lower cover.
45286B
6.REMOVE STEERING COLUMN UPPER COVER
|
Remove in this Direction |
Detach the 2 claws and 2 guides to remove the steering column upper cover.
7.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Disconnect the connectors from the combination switch assembly with spiral cable sub-assembly.
|
Remove in this Direction |
Detach the 3 claws. Remove the combination switch assembly with spiral cable sub-assembly from the steering column sub-assembly.
73900
8.REMOVE NO. 1 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY
45219
9.DISCONNECT STEERING SLIDING YOKE
45025D
10.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Remove the 3 bolts and No. 1 steering column hole cover sub-assembly.
45250
11.REMOVE STEERING COLUMN ASSEMBLY
Remove the bolt and 2 nuts, and then pull out the steering column assembly together with the steering sliding with coupling yoke.