Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type)
RM3250E _56 Audio / Visual / Telematics _038052 AUDIO / VIDEO _0182296 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B15C0  Short in GPS Antenna  B15C1  Open in GPS Antenna  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation antenna assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C0 Short in GPS Antenna Navigation antenna error
·

Navigation antenna assembly

·

No. 2 navigation antenna cord sub-assembly

·

Antenna cord sub-assembly

·

Radio and display receiver assembly


B15C1 Open in GPS Antenna Error of the power source to the navigation antenna
·

Navigation antenna assembly

·

No. 2 navigation antenna cord sub-assembly

·

Antenna cord sub-assembly

·

Radio and display receiver assembly



WIRING DIAGRAM

E321062E02
1.125,0.125 4.948,0.323 3.823,0.198 10 false Navigation Antenna Assembly 2.073,1.885 3.646,2.24 1.573,0.354 10 false No. 2 Navigation Antenna Cord Sub-assembly 4.448,1.896 5.365,2.25 0.917,0.354 10 false Antenna Cord Sub-assembly 4.188,1.156 4.427,1.344 0.24,0.188 10 false 3a 5.552,1.177 5.792,1.365 0.24,0.188 10 false 1a 5.604,0.677 5.844,0.865 0.24,0.188 10 false 1 4.177,0.708 4.417,0.896 0.24,0.188 10 false 3 6.104,0.792 6.813,1 0.708,0.208 10 false GPS 5.958,1.865 7.156,2.219 1.198,0.354 10 false Radio and Display Receiver Assembly 3.406,1.156 3.646,1.344 0.24,0.188 10 false 3a 3.479,0.708 3.719,0.896 0.24,0.188 10 false 3 2.031,1.177 2.271,1.365 0.24,0.188 10 false 3a 2.042,0.708 2.281,0.896 0.24,0.188 10 false 3

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the radio and display receiver assembly, it is necessary to perform the vehicle contractsetting for Connected Services (w/ Connected Services Function).

·

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



PROCEDURE

1.CHECK DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT NAVIGATION ANTENNA ASSEMBLY
2.INSPECT NAVIGATION ANTENNA ASSEMBLY


Result:
Proceed to
OK
NG



OK

3.CHECK NO. 2 NAVIGATION ANTENNA CORD SUB-ASSEMBLY

NG

3.CHECK NO. 2 NAVIGATION ANTENNA CORD SUB-ASSEMBLY
a.

b.

Result:
Proceed to
OK
NG



OK

4.CHECK ANTENNA CORD SUB-ASSEMBLY

NG

REPLACE NO. 2 NAVIGATION ANTENNA CORD SUB-ASSEMBLY

4.CHECK ANTENNA CORD SUB-ASSEMBLY
a.
E317092C03
1.24,1.552 1.417,1.271 true 1.354,2.99 1.531,2.719 true 2.115,2.354 1.979,2.354 1.979,2.354 1.667,2.604 true 0.26,0.219 0.469,0.396 0.208,0.177 10 false *a 0.333,2.021 0.542,2.198 0.208,0.177 10 false *b 1.115,1.531 1.323,1.708 0.208,0.177 10 false 3a 1.188,2.969 1.396,3.146 0.208,0.177 10 false 1a 2.177,2.24 2.656,2.469 0.479,0.229 10 false GPS
*a Front view of wire harness connector
(to No. 2 Navigation Antenna Cord Sub-assembly)
*b Front view of wire harness connector
(to Radio and Display Receiver Assembly)


Disconnect the antenna connector from the No. 2 navigation antenna cord sub-assembly.


b.

Disconnect the antenna connector from the radio and display receiver assembly.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 1 (GPS) Always Below 1 Ω
3a - 1a Always Below 1 Ω
3 - Body ground Always 10 kΩ or higher
3a - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

NG

REPLACE ANTENNA CORD SUB-ASSEMBLY