Home › Engine / Hybrid System › 5L-E LUBRICATION › LUBRICATION SYSTEM › from 2016.01
RM3250E _51 Engine / Hybrid System _049916 5L-E LUBRICATION _0244986 LUBRICATION SYSTEM G

5L-E LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:
·
A343690

To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hands and clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.

·
A343695

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A343700

To prevent burns, do not remove the engine oil pressure switch assembly while the engine is hot.



PROCEDURE

Hide 1. CHECK ENGINE OIL QUALITY

a.

Check the oil for deterioration, water contamination, discoloration or thinning.

If the quality is visibly poor, replace the engine oil and oil filter sub-assembly.

Click hereEngine / Hybrid System>5L-E LUBRICATION>OIL AND OIL FILTER>REPLACEMENT


Hide 2. CHECK ENGINE OIL LEVEL

a.

Warm up the engine and then wait for 5 minutes after turning the engine off. The oil level should be between the low level and full level marks of the engine oil level dipstick.

If low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not add engine oil above the full level mark.



Hide 3.INSPECT OIL PRESSURE

CAUTION:
·

To prevent injury due to contact with an operating fan and generator V-belt or cooling fan, keep your hands and clothing away from the fan and generator V-belt and cooling fans when working in the engine compartment with the engine running.

·

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·

To prevent burns, do not remove the engine oil pressure switch assembly while the engine is hot.



a.

Remove the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>5L-E LUBRICATION>OIL PRESSURE SWITCH>REMOVAL


b.
A378211C01
2.281,0.375 2.74,0.375 true 2.052,0.26 2.26,0.458 0.208,0.198 10 true *a
*a Oil Pressure Gauge


Install an oil pressure gauge.


c.

Warm up the engine.


d.

Measure the oil pressure.

Standard Oil Pressure
Condition Specified Condition
Idling 29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm 294 to 539 kPa (3.0 to 5.5 kgf/cm2, 43 to 78 psi)

If the result is not as specified, check the oil pump.

Click hereEngine / Hybrid System>5L-E LUBRICATION>OIL PUMP>INSPECTION


e.

Remove the oil pressure gauge.


f.

Install the engine oil pressure switch assembly.

Click hereEngine / Hybrid System>5L-E LUBRICATION>OIL PRESSURE SWITCH>INSTALLATION