83530
1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the cylinder block sub-assembly.
Do not start the engine within 1 hour of installation.
Connect the connector to the engine oil pressure switch assembly.
29300A
2.CONNECT VACUUM PUMP OIL INLET HOSE
17881
3.INSTALL NO. 1 AIR CLEANER HOSE
4.INSPECT FOR OIL LEAK