Home › Engine / Hybrid System › 5L-E LUBRICATION › ENGINE OIL COOLER › from 2016.01
RM3250E _51 Engine / Hybrid System _049916 5L-E LUBRICATION _0244990 ENGINE OIL COOLER A

5L-E LUBRICATION  ENGINE OIL COOLER  INSTALLATION  


PROCEDURE

Hide 15710 1.INSTALL OIL COOLER ASSEMBLY

a.

Install 2 new gaskets and the oil cooler assembly to the oil filter bracket with the 4 nuts.

Torque:
15.5 N*m (158 kgf*cm, 11 ft.*lbf)


Hide 15609 2.INSTALL OIL FILTER BRACKET SUB-ASSEMBLY

a.

Install a new gasket and the oil filter bracket sub-assembly to the cylinder block sub-assembly with the 11 bolts and 2 nuts.

Torque:
29.5 N*m (301 kgf*cm, 22 ft.*lbf)


Hide 15601 3.INSTALL OIL FILTER SUB-ASSEMBLY

Hide 29300A 4.CONNECT VACUUM PUMP OIL INLET HOSE

a.
A378225C01
1.406,1.417 1.594,0.844 1.594,0.844 1.792,0.844 true 1.823,0.74 2.042,0.938 0.219,0.198 10 true *a
*a Stopper Bar


Connect the vacuum pump oil inlet hose to the cylinder block sub-assembly with 2 new gaskets and the union bolt.

Torque:
14 N*m (143 kgf*cm, 10 ft.*lbf)

HINT:

When tightening the vacuum pump oil inlet hose, hang the stopper bar of the vacuum pump oil inlet hose on the filter bracket sub-assembly to prevent the vacuum pump oil inlet hose from rotating.



Hide 27020 6.INSTALL GENERATOR ASSEMBLY