Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › ECD SYSTEM(w/ Urea SCR System) › from 2016.03
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0262511 ECD SYSTEM(w/ Urea SCR System) C

2GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  P209F  Reductant Tank Heater Control Circuit Performance  P20BA  Reductant Heater "A" Control Circuit Performance  


DESCRIPTION

Refer to DTC P202B.

Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ Urea SCR System)>P202B

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P209F Reductant Tank Heater Control Circuit Performance When the tank heater is operating (temperature sensor value is equal to or less than a fixed value), overcurrent is detected multiple times (1 trip detection logic). Urea pump Comes on DTC stored
P20BA Reductant Heater "A" Control Circuit Performance When the urea tube with heater is operating (ambient temperature sensor value is equal to or less than a fixed value), overcurrent is detected multiple times (1 trip detection logic). Urea tube with heater assembly Comes on DTC stored

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P209F Reductant Tank Heater (Active Test)
P20BA Reductant Pipe Heater (Active Test)

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes.


d.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 234
Result:
Result Proceed to
DTC P209F or P20BA is output A
DTC P209F or P20BA and other DTCs are output* B


HINT:

*: If any other DTCs (CAN communication malfunctions or open/short circuits) are output, perform troubleshooting for those DTCs first.




A

2.CHECK AROUND BOTTOM OF VEHICLE

B

2.CHECK AROUND BOTTOM OF VEHICLE
a.

Check around the bottom of the vehicle.

HINT:

If the urea solution dries on an object, deposition occurs and leaves behind a white powder.


Area to check:

·

Areas connecting the urea pump and urea injector set.

·

Perforations in the urea tank sub-assembly.

·

Connectors not connected properly.

·

Clogging of the cooling fins of the urea injector set.

HINT:

If the cooling fins are clogged with foreign matter, remove the foreign matter and clean the cooling fins.




b.

Repair any trouble areas.


Result:
Proceed to
NEXT



NEXT

3.PERFORM ACTIVE TEST USING GTS (REDUCTANT PURGE)
3.PERFORM ACTIVE TEST USING GTS (REDUCTANT PURGE)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 234

d.

Turn the ignition switch off and wait for at least 30 seconds.


e.

Turn the ignition switch to ON and turn the GTS on.


f.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Pump Check (Backward).


g.

Perform the Active Test.

Powertrain > Engine > Active Test
Tester Display
Reductant Pump Check (Backward)
50004 234 322

h.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Purge.


i.

Perform the Active Test.

HINT:

Perform the Reductant Purge to draw the urea solution back into the urea tank sub-assembly from the urea injector set.


Powertrain > Engine > Active Test
Tester Display
Reductant Purge
50004 234 323

Result:
Proceed to
NEXT



NEXT

4.CHECK DTC OUTPUT (DTC P209F)
4.CHECK DTC OUTPUT (DTC P209F)
a.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Tank Heater.


b.

Perform the Active Test.

Powertrain > Engine > Active Test
Tester Display
Reductant Tank Heater
50004 234 319

c.

Enter the following menus: Powertrain / Engine / Trouble Codes.


d.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 234

Result:
Result Proceed to
DTC P209F is output A
No DTC is output B



A

5.REPLACE UREA PUMP

B

6.CHECK DTC OUTPUT (DTC P20BA)
5.REPLACE UREA PUMP

Result:
Proceed to
NEXT



NEXT

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
6.CHECK DTC OUTPUT (DTC P20BA)
a.

Enter the following menus: Powertrain / Engine / Active Test / Reductant Pipe Heater.


b.

Perform the Active Test.

Powertrain > Engine > Active Test
Tester Display
Reductant Pipe Heater
50004 234 318

c.

Enter the following menus: Powertrain / Engine / Trouble Codes.


d.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 234

Result:
Result Proceed to
DTC P20BA is output A
No DTC is output B



A

7.REPLACE UREA TUBE WITH HEATER ASSEMBLY

B

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
7.REPLACE UREA TUBE WITH HEATER ASSEMBLY
a.

Replace the urea tube with heater assembly.


Result:
Proceed to
NEXT



NEXT

8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
8.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 234

d.

Turn the ignition switch off and wait for at least 30 seconds.


e.

Turn the ignition switch to ON and turn the GTS on.


f.

Using the GTS, perform the following Active Tests.

·

To check DTC P209F:

Enter the following menus: Powertrain / Engine / Active Test / Reductant Tank Heater.

·

To check DTC P20BA:

Enter the following menus: Powertrain / Engine / Active Test / Reductant Pipe Heater.



g.

Enter the following menus: Powertrain / Engine / Trouble Codes.


h.

Confirm that the DTC is not output again.

Powertrain > Engine > Trouble Codes
50001 234

Result:
Proceed to
NEXT



NEXT

END