Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › ECD SYSTEM(w/ Urea SCR System) › from 2016.08
RM3250E _51 Engine / Hybrid System _038005 2GD-FTV ENGINE CONTROL _0262511 ECD SYSTEM(w/ Urea SCR System) C

2GD-FTV ENGINE CONTROL  ECD SYSTEM(w/ Urea SCR System)  P2200  NOx Sensor Circuit Bank 1 Sensor 1  P220E  NOx Sensor Heater Control Circuit Range/Performance Bank 1 Sensor 1  


DESCRIPTION

A nitrogen oxides sensor is installed in the front exhaust pipe assembly in order to detect the concentration of NOx and O2 in the exhaust gas.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P2200 NOx Sensor Circuit Bank 1 Sensor 1 An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more (2 trip detection logic). Nitrogen oxides sensor assembly Comes on DTC stored
P220E NOx Sensor Heater Control Circuit Range/Performance Bank 1 Sensor 1 An open or short circuit occurs in the nitrogen oxides sensor circuit for 3 seconds or more (2 trip detection logic). Nitrogen oxides sensor assembly Comes on DTC stored

Related Data List
DTC No. Data List
P2200
P220E
NOx Density B1S1

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P2200
P220E
Ignition switch ON for 3 seconds or more

CAUTION / NOTICE / HINT

HINT:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.


PROCEDURE

1.CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2200 OR P220E)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Enter the following menus: Powertrain / Engine / Trouble Codes.


d.

Read the DTCs.

Powertrain > Engine > Trouble Codes
50001 234
Result:
Result Proceed to
DTC P2200, P220E is output A
DTC P2200 or P220E and other DTCs are output* B


HINT:

*: If any other DTCs are output, perform troubleshooting for those DTCs first.




A

2.REPLACE NITROGEN OXIDES SENSOR ASSEMBLY

B

2.REPLACE NITROGEN OXIDES SENSOR ASSEMBLY
a.

Replace the nitrogen oxides sensor assembly.

Click hereEngine / Hybrid System>2GD-FTV ENGINE CONTROL>NITROGEN OXIDES SENSOR>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
3.CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 234

d.

Turn the ignition switch off and wait for 30 seconds or more.


e.

Ignition switch to ON for 3 seconds or more.


f.

Enter the following menus: Powertrain / Engine / Trouble Codes.


g.

Confirm that the DTC is not output again.

Powertrain > Engine > Trouble Codes
50001 234

Result:
Proceed to
NEXT



NEXT

END