Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER(for Double Cab) › from 2016.08
RM3250E _53 Suspension _057180 TIRE PRESSURE MONITORING _0279607 TIRE PRESSURE WARNING RECEIVER(for Double Cab) A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER(for Double Cab)  INSTALLATION  


PROCEDURE

Hide 89760C 1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

a.

Connect the connector to the tire pressure warning ECU and receiver.


b.

Attach the 2 guides to temporarily install the tire pressure warning ECU and receiver.


c.

Install the bolt.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


Hide 64271C 2.INSTALL BACK PANEL TRIM

a.
C354067C01
0.115,0.104 0.427,0.302 0.313,0.198 10 true *A 0.104,2.656 0.417,2.854 0.313,0.198 10 true *B
*A for Type A
*B for Type B


Install the back panel trim with the 5 clips.


Hide 62512 3.INSTALL QUARTER INSIDE TRIM BOARD LH

Hide 62511 4.INSTALL QUARTER INSIDE TRIM BOARD RH

Hide 73178B 5.INSTALL SEAT BELT ANCHOR COVER CAP

Hide 62514A 7.INSTALL LOWER QUARTER TRIM PANEL LH

Hide 62513A 8.INSTALL LOWER QUARTER TRIM PANEL RH

Hide 11.INSTALL REAR SEAT ASSEMBLY

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION