Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER(for Single Cab) › from 2016.08
RM3250E _53 Suspension _057180 TIRE PRESSURE MONITORING _0279608 TIRE PRESSURE WARNING RECEIVER(for Single Cab) A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER(for Single Cab)  INSTALLATION  


PROCEDURE

Hide 89760C 1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

a.

Connect the connector to the tire pressure warning ECU and receiver.


b.

Attach the 2 guides to temporarily install the tire pressure warning ECU and receiver.


c.

Install the bolt.

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION