Home › Audio / Visual / Telematics › AUDIO / VIDEO › AMPLIFIER ANTENNA › from 2016.08
RM3250E _56 Audio / Visual / Telematics _038052 AUDIO / VIDEO _0182786 AMPLIFIER ANTENNA A

AUDIO / VIDEO  AMPLIFIER ANTENNA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)

CAUTION:
B414214

w/ Airbag System:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type C)>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 86309E 4.REMOVE ROOF ANTENNA POLE SUB-ASSEMBLY

Hide 86300B 5.REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY

a.
E348942C01
0,0 0,0 false
V113147

Remove in this Direction


w/o Telematics System

i.

Disconnect the connector and detach the clamp.


ii.

Remove the nut.



b.
E348937C01
0,0 0,0 false
V113147

Remove in this Direction


w/ Telematics System

i.

Disconnect the connectors and detach the clamp.


ii.

Remove the nut.



c.
E310291

Detach the claws and remove the No. 1 amplifier antenna assembly.