When the ignition switch is ON, the power window regulator master switch assembly sends remote up and down signals to each power window regulator motor assembly via LIN communication.
w/ Automatic Light Control System:
If the body ECU has been replaced, it is necessary to initialize the body ECU.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION
w/ Door Control Battery:
As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
*1: for LHD
*2: for RHD
Disconnect the G27 body ECU connector.
Disconnect the K6*1 or J12*2 power window regulator master switch connector.
Disconnect the J9*1 front power window regulator motor assembly RH connector.
Disconnect the K9*2 front power window regulator motor assembly LH connector.
Disconnect the M4 rear power window regulator motor assembly LH connector.
Disconnect the L4 rear power window regulator motor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G27-3 (LIN2) - K6-17 (LIN1)*1 | Always | Below 1 Ω |
| G27-3 (LIN2) - J12-17 (LIN1)*2 | Always | Below 1 Ω |
| G27-3 (LIN2) - J9-9 (LIN)*1 | Always | Below 1 Ω |
| G27-3 (LIN2) - K9-9 (LIN)*2 | Always | Below 1 Ω |
| G27-3 (LIN2) - M4-9 (LIN) | Always | Below 1 Ω |
| G27-3 (LIN2) - L4-9 (LIN) | Always | Below 1 Ω |
| G27-3 (LIN2) - Body ground | Always | 10 kΩ or higher |
| K6-17 (LIN1) - Body ground*1 | Always | 10 kΩ or higher |
| J12-17 (LIN1) - Body ground*2 | Always | 10 kΩ or higher |
| J9-9 (LIN) - Body ground*1 | Always | 10 kΩ or higher |
| K9-9 (LIN) - Body ground*2 | Always | 10 kΩ or higher |
| M4-9 (LIN) - Body ground | Always | 10 kΩ or higher |
| L4-9 (LIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the power window regulator master switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL
Check that the remote up and down functions using the power window regulator master switch assembly can operate all the power windows.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Remote up and down functions are normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
A
B
C