If the body ECU has been replaced, it is necessary to initialize the body ECU.*1
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.*2
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION
*1: w/ Automatic Light Control System
*2: w/ Door Control Battery
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
*1: w/ Door Control Battery
*2: w/o Door Control Battery
*3: for LHD
*4: for RHD
*1: for Double Cab
*2: for LHD
*3: for RHD
*1: When the door unlock detection switch detects an unlock position signal after a door lock operation has been performed, a door lock operation will be performed 3 times.
*2: w/ Speed-sensitive Automatic Door Lock Function
*3: w/o Smart Entry and Start System
*4: for Double Cab
*5: for LHD
*6: for RHD