Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
73220
1.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
| *a | Bolt A |
| *b | Bolt B |
Attach the 2 guides and temporarily install the front seat outer belt assembly LH with the 2 bolts.
Tighten the 2 bolts in the order shown in the illustration.
| *1 | Locking Button |
Connect the pretensioner connector and lock the locking button as shown in the illustration.
Securely lock the locking button.
Install the bolt and connect the shoulder anchor of the front seat outer belt assembly LH.
Check that the ELR locks.
The check should be performed with the front seat outer belt assembly LH installed.
With the belt assembly installed, check that the belt locks when it is pulled out quickly.
73178A
2.INSTALL SEAT BELT ANCHOR COVER CAP
67604
3.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
73220
4.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH (for Floor Anchor)
Install the bolt and connect the floor anchor of the front seat outer belt assembly LH.
73233
5.INSTALL LAP BELT OUTER ANCHOR COVER
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
7.CHECK SRS WARNING LIGHT