When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
No. 3 injection pipe sub-assembly ·
No. 4 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing Gear Case Assembly |
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
When replacing the common rail assembly, do not remove the foreign object mixing prevention caps of the common rail assembly until just before the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly are connected to the common rail assembly.
17136
1.INSTALL NO. 2 INTAKE MANIFOLD INSULATOR
Install the No. 2 intake manifold insulator to the cylinder head sub-assembly.
23810A
2.INSTALL COMMON RAIL ASSEMBLY
Install the common rail assembly to the cylinder head sub-assembly with the 2 bolts.
Connect the connector to the pressure discharge valve.
Connect the connector to the fuel pressure sensor connector.
23804C
3.INSTALL FUEL INLET PIPE SUB-ASSEMBLY
11452
4.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
23770
5.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
23704
6.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY
23701
7.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
15601
8.INSTALL OIL FILTER SUB-ASSEMBLY
17118
9.INSTALL MANIFOLD STAY
17940D
10.INSTALL INTERCOOLER ASSEMBLY
11.ADD ENGINE OIL
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
13.BLEED AIR FROM FUEL SYSTEM
14.INSPECT FOR FUEL LEAK
15.INSPECT FOR OIL LEAK
16.INSPECT ENGINE OIL LEVEL
51442
17.INSTALL NO. 2 ENGINE UNDER COVER
51410
18.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY