When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
No. 3 injection pipe sub-assembly ·
No. 4 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing Gear Case Assembly |
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
When replacing the common rail assembly, do not remove the foreign object mixing prevention caps of the common rail assembly until just before the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly are connected to the common rail assembly.
23810A
1.INSTALL COMMON RAIL ASSEMBLY
Install the common rail assembly to the cylinder head sub-assembly with the 2 bolts.
Connect the connector to the pressure discharge valve.
Connect the connector to the fuel pressure sensor connector.
23804C
2.INSTALL FUEL INLET PIPE SUB-ASSEMBLY
11452
3.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
23770
4.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
23704
5.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY
23701
6.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
15601
7.INSTALL OIL FILTER SUB-ASSEMBLY
17118
8.INSTALL MANIFOLD STAY
17113E
9.INSTALL NO. 1 INTAKE PIPE
10.ADD ENGINE OIL
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12.BLEED AIR FROM FUEL SYSTEM
13.INSPECT FOR FUEL LEAK
14.INSPECT FOR OIL LEAK
15.INSPECT ENGINE OIL LEVEL
51442
16.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)
51410
17.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)