When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
No. 3 injection pipe sub-assembly ·
No. 4 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing Gear Case Assembly |
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
17111
1.INSTALL INTAKE MANIFOLD
Install the new gasket to the cylinder head sub-assembly.
Temporarily install the intake manifold with the 4 bolts 2 nuts.
Tighten the 4 bolts and 2 nuts in the order shown in the illustration.
23770
2.INSTALL NO. 2 NOZZLE LEAKAGE PIPE ASSEMBLY
23704
3.INSTALL NO. 4 INJECTION PIPE SUB-ASSEMBLY
23701
4.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
17861F
5.INSTALL INTAKE AIR CONNECTOR
Install a new gasket and the intake air connector to the intake manifold with the 2 nuts and bolt.
17873A
6.INSTALL NO. 2 INTAKE AIR CONNECTOR BRACKET
Install the No. 2 intake air connector bracket to the cylinder head sub-assembly and intake manifold with the 3 bolts.
25861C
7.INSTALL VACUUM SWITCHING VALVE BRACKET
Install the vacuum switching valve bracket with the 2 bolts.
11452
8.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
Apply a small amount of clean engine oil to the O-ring.
Install a new O-ring to the engine oil level dipstick guide.
Install the engine oil level dipstick guide with the bolt.
Install the injection pipe clamp with the bolt.
Install the engine oil level dipstick.
17118
9.INSTALL MANIFOLD STAY
Install the manifold stay to the intake manifold and cylinder block sub-assembly with the 2 bolts.
The manifold stay indented area (labeled A) must face the intake manifold.
26100G
10.INSTALL DIESEL THROTTLE BODY ASSEMBLY
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12.BLEED AIR FROM FUEL SYSTEM
13.INSPECT FOR FUEL LEAK
14.INSPECT FOR OIL LEAK
15.INSPECT ENGINE OIL LEVEL