Home › Engine / Hybrid System › 2KD-FTV COOLING › WATER PUMP
RM33J0E _51 Engine / Hybrid System _038451 2KD-FTV COOLING _0196376 WATER PUMP A

2KD-FTV COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Injector assembly (including shuffling the injector assemblies between the cylinders)

·

Common rail assembly

·

Cylinder head sub-assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

No. 3 injection pipe sub-assembly

·

No. 4 injection pipe sub-assembly


·

Supply pump assembly

·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing Gear Case Assembly


Fuel inlet pipe sub-assembly

·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51410 3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY (for 4WD and Pre-Runner)

Hide 16571C 6.REMOVE NO. 1 RADIATOR HOSE

Hide 44360 7.DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

Hide 44369A 8.REMOVE OIL RESERVOIR BRACKET

Hide 16470 9.REMOVE RADIATOR RESERVOIR

Hide 16711 10.REMOVE FAN SHROUD

Hide 88320 11.DISCONNECT COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)

Hide 88440D 12.REMOVE NO. 2 IDLE PULLEY ASSEMBLY

Hide 12511C 14.REMOVE GENERATOR BRACKET

Hide 16620 15.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 23701 16.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 23704 17.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

Hide 11201 18.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 11322A 19.REMOVE NO. 1 TIMING BELT COVER

Hide 13505 21.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

Hide 11322B 23.REMOVE NO. 2 TIMING BELT COVER

Hide 16100 24.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A252180C02
2.26,1.5 2.323,1.563 false
V100135

Bolt
V100136

Nut


Remove the 5 bolts, 2 nuts, engine water pump assembly and gasket.