This DTC is output when an open circuit in the transfer shift motor drive circuit is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P17A8 | Transfer Shift Motor Control Circuit Circuit Open | ·
Diagnosis Condition: While switching between H2 and H4 or while switching between H4 and L4 (transfer shift motor operating) with the ignition switch turned to ON ·
Malfunction Status: Open circuit in the transfer shift motor drive circuit ·
Malfunction Time: 0.03 seconds or more ·
Other: 1 trip detection logic |
·
Wire harness and connector ·
4 wheel drive control ECU ·
Transfer shift actuator assembly |
Refer to DTC P17A9.
Click hereDrivetrain>VF2CM TRANSFER / 4WD / AWD>TOUCH SELECT 2-4 AND HIGH-LOW SYSTEM>P17A9
Disconnect the C40 4 wheel drive control ECU connector.
Disconnect the C41 transfer shift actuator assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C40-8 (TM1) - C41-2 (TM1) | Always | Below 1 Ω |
| C40-7 (TM2) - C41-1 (TM2) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the C41 transfer shift actuator assembly connector.
| *a | Component without harness connected
(Transfer Shift Actuator Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (TM1) - 1 (TM2) | Always | 1.5 to 10 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG