11381A
1.INSTALL REAR ENGINE OIL SEAL
Apply MP grease to the lip of a new rear engine oil seal.
Keep the lip free of foreign matter.
Do not allow MP grease to contact the dust seal.
Using SST and a hammer, tap in the rear engine oil seal to the rear engine oil seal retainer edge.
The acceptable depth from the top of the rear engine oil seal retainer is 0 to 0.8 mm (0 to 0.0315 in.)
Keep the lip free from foreign matter.
Do not tap the rear engine oil seal at an angle.
Make sure that the engine rear oil seal is properly installed.
11355
2.INSTALL REAR END PLATE
13405
3.INSTALL FLYWHEEL SUB-ASSEMBLY
31250
4.INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission)
31210
5.INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission)
33030
6.INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
7.INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)