Home › Engine / Hybrid System › 1GD-FTV FUEL › COMMON RAIL › from 2015.11
RM33J0E _51 Engine / Hybrid System _038422 1GD-FTV FUEL _0199073 COMMON RAIL A

1GD-FTV FUEL  COMMON RAIL  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.

Replaced Parts (A) Pipes Requiring New Replacement
·

Injector assembly (including shuffling the injector assemblies between the cylinders)

·

Common rail assembly

·

Cylinder head sub-assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly


·

Supply pump assembly

·

Common rail assembly

·

Cylinder block sub-assembly

·

Cylinder head sub-assembly

·

Cylinder head gasket

·

Timing chain case assembly


·

No. 1 injection pipe sub-assembly

·

No. 2 injection pipe sub-assembly

·

Fuel inlet pipe sub-assembly



·

After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly, clean them with a brush and compressed air.

·

The common rail assembly is a precision instrument. Do not use the common rail assembly if it is struck or dropped.

·

Hold the common rail assembly itself during removal and installation. Do not hold the pressure discharge valve or fuel pressure sensor, etc.

·

Make sure foreign matter does not enter the fuel path.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 25800 3.REMOVE EGR COOLER SUB-ASSEMBLY AND NO. 2 EGR VALVE ASSEMBLY WITH ELECTRIC EGR CONTROL VALVE ASSEMBLY

Hide 4.REMOVE WIRING HARNESS CLAMP BRACKET

Hide 5.REMOVE NO. 1 AND NO. 2 INJECTION PIPE SUB-ASSEMBLY

Hide 23804D 6.REMOVE NO. 4 FUEL PIPE SUB-ASSEMBLY (w/ DPF)

Hide 23804C 7.REMOVE FUEL INLET PIPE SUB-ASSEMBLY

Hide 23282D 8.REMOVE NO. 4 FUEL HOSE

a.
A344943

Slide the clamp and disconnect the No. 4 fuel hose from the common rail assembly.


Hide 23810A 9.REMOVE COMMON RAIL ASSEMBLY

a.
A344944

except i-ART:

i.

Detach the wire harness clamp.


ii.

Disconnect the fuel pressure sensor connector from the common rail assembly.



b.
A379199C01
0.052,0.042 0.365,0.198 0.313,0.156 10 true *a 0.083,2.469 0.396,2.625 0.313,0.156 10 true *b
*a for i-ART
*b except i-ART


Remove the 2 nuts and common rail assembly.

NOTICE:

except i-ART:

Do not remove the pressure discharge valve or fuel pressure sensor.