Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2016.07
RM33J0E _58 Vehicle Interior _038499 METER / GAUGE / DISPLAY _0189806 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Tachometer Malfunction  


DESCRIPTION

In this circuit, the combination meter assembly receives engine speed signals from the ECM via the CAN communication system. The combination meter assembly displays the engine speed calculated based on the data received from the ECM.

WIRING DIAGRAM

E255800E14
4.771,2.563 6.99,2.813 2.219,0.25 10 false Combination Meter Assembly 1.708,2.573 3.938,3.021 2.229,0.448 10 false ECM 0.802,3.375 3.563,3.656 2.76,0.281 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, make sure to replace it with a new one.

·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.



PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR

Body Electrical > Combination Meter > Clear DTCs
50002 122
OK:

DTC is not output



Result:
Result Proceed to
OK (for Diesel Engine) A
OK (for Gasolline Engine) B
NG C



A

2.CHECK FOR DTC (ECD SYSTEM)

B

4.CHECK FOR DTC (SFI SYSTEM)

C

2.CHECK FOR DTC (ECD SYSTEM)

OK

3.PERFORM ACTIVE TEST USING GTS (TACHOMETER OPERATION)

NG

3.PERFORM ACTIVE TEST USING GTS (TACHOMETER OPERATION)
a.

Using the GTS, perform the Active Test.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
TachoMeter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000 or 6000* (rpm) *: for Gasoline Engine
Body Electrical > Combination Meter > Active Test
Tester Display
TachoMeter Operation
50004 122 2
OK:

Tachometer indication is normal.



Result:
Proceed to
OK
NG



OK

NG

REPLACE COMBINATION METER ASSEMBLY

4.CHECK FOR DTC (SFI SYSTEM)
a.

Check for DTCs.

for 2TR-FE: Click hereEngine / Hybrid System>2TR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR

for 2TR-FBE: Click hereEngine / Hybrid System>2TR-FBE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR

Powertrain > Engine > Trouble Codes
50001 234
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

3.PERFORM ACTIVE TEST USING GTS (TACHOMETER OPERATION)

NG