Home › Engine / Hybrid System › 2TR-FBE INTAKE / EXHAUST › EXHAUST MANIFOLD › from 2016.07
RM33J0E _51 Engine / Hybrid System _053777 2TR-FBE INTAKE / EXHAUST _0267087 EXHAUST MANIFOLD A

2TR-FBE INTAKE / EXHAUST  EXHAUST MANIFOLD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the exhaust manifold removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
·
A343693

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.

·
A350542

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.



PROCEDURE

Hide 53882F 1.REMOVE FRONT FENDER SEAL RH

Hide 25710 2.REMOVE AIR SWITCHING VALVE ASSEMBLY

Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.

Disconnect the air fuel ratio sensor connector and detach the 3 wire harness clamps.


b.

for Pre-Runner:

Disconnect the heated oxygen sensor connector and detach the 4 wire harness clamps.


c.

for 4WD:

Disconnect the heated oxygen sensor connector and detach the wire harness clamp.


d.

Remove the 4 bolts, 2 nuts and 2 compression springs.


e.

Remove the front exhaust pipe assembly from the No. 1 exhaust pipe support.


f.

Remove the 2 gaskets.


Hide 17118 4.REMOVE MANIFOLD STAY

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A345967

Remove the 3 bolts and manifold stay.


Hide 17141 5.REMOVE EXHAUST MANIFOLD

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.


a.
A346102

Remove the 8 nuts and exhaust manifold.


b.

Remove the gasket.