Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.07
RM33J0E _51 Engine / Hybrid System _038462 CRUISE CONTROL _0181542 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the cruise control indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

w/ Multi-information Display:

The cruise control indicator light illuminates when the cruise control system has been turned on using the cruise control main switch (ON/OFF). If a malfunction is detected, the cruise control indicator light goes off and a warning message is displayed.

·

w/o Multi-information Display:

The cruise control indicator light in the combination meter assembly changes to yellow when a malfunction occurs during cruise control driving.

·

The cruise control indicator light circuit uses CAN communication. If the cruise control indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, make sure to replace it with a new one.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the GTS, perform the Active Test.

i.

w/ Multi-information Display (for TFT Display Type):

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7
OK:

The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation



ii.

w/ Multi-information Display (for Dot Display Type):

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise indicator light (Green) OFF or ON -
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. Lamp Cruise
50004 122 46
OK:

Cruise control indicator light turns ON/OFF



iii.

w/o Multi-information Display:

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. Lamp Cruise Cruise indicator light (Green) OFF or ON -
Cruise Indicator Cruise indicator light (Yellow) OFF or ON -
OK:

Cruise control indicator light turns ON/OFF




Result:
Result Proceed to
OK A
NG B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
CCS Indicator M-CPU Cruise control indicator light signal (Main-CPU) ON or OFF ON: Cruise control indicator light turns on
OFF: Cruise control indicator light turns off
-
Powertrain > Cruise Control > Data List
Tester Display
CCS Indicator M-CPU
50003 237 12

Result:
Result Proceed to
The indicator operates normally according to the on and off operations A
The GTS screen display changes from off to on, but the cruise control indicator light in the combination meter assembly does not illuminate B
The cruise control indicator light in the combination meter assembly does not illuminate and the GTS screen display does not change from off C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C