Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › from 2016.07
RM33J0E _51 Engine / Hybrid System _038462 CRUISE CONTROL _0181542 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

The ECM turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.

·

The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.

·

The cruise control indicator light circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, make sure to replace it with a new one.


PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

According to the display on the GTS, perform the Active Test.

i.

w/ Multi-information Display (for TFT Display Type):

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7
OK:

The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation



ii.

except Multi-information Display (for TFT Display Type):

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Indicat. SET
Body Electrical > Combination Meter > Active Test
Tester Display
Indicat. SET
50004 122 91
OK:

Cruise control SET indicator light turns ON/OFF




Result:
Result Proceed to
OK A
NG B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Enter the following menus: Powertrain / Cruise Control / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
SET/COAST Switch -SET switch signal ON or OFF ON: -SET switch on
OFF: -SET switch off
-
Powertrain > Cruise Control > Data List
Tester Display
SET/COAST Switch
50003 237 22
OK:

When the cruise control main switch (-SET switch) is operated, the display changes as shown above.



Result:
Result Proceed to
The indicator operates normally according to the on and off operations A
The GTS screen display changes from off to on, but the cruise control SET indicator light in the combination meter assembly does not illuminate B
The cruise control SET indicator light in the combination meter assembly does not illuminate, and the indication in the GTS screen display stays at OFF C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C