Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
81560
1.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
|
Slide in this Direction |
|
Protective Tape |
Slide the rear combination light assembly LH towards the vehicle front to attach the pin and guide.
Install the 2 screws.
Pass the wire harness into the vehicle and connect the grommet.
Attach the wire harness clamp.
Place your hand between the quarter inside trim board LH and the body to connect the connector.
62512
2.CONNECT QUARTER INSIDE TRIM BOARD LH
73233B
3.INSTALL REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER
67935
4.INSTALL BACK DOOR SCUFF PLATE
5.INSTALL REAR NO. 2 SEAT ASSEMBLY LH
52159
6.INSTALL REAR BUMPER COVER