Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
52159
1.REMOVE REAR BUMPER COVER
2.REMOVE REAR NO. 2 SEAT ASSEMBLY LH
67935
3.REMOVE BACK DOOR SCUFF PLATE
73233B
4.REMOVE REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER
62512
5.DISCONNECT QUARTER INSIDE TRIM BOARD LH
Disconnect the rear side of the quarter inside trim board LH so that the connector of the rear combination light assembly LH can be disconnected.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
81560
6.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
Place your hand between the quarter inside trim board LH and the body to disconnect the connector.
|
Pull in this Direction |
Detach the wire harness clamp.
Disconnect the grommet and pull out the wire harness.
|
Protective Tape |
Apply protective tape around the rear combination light assembly LH.
Remove the 2 screws.
|
Place Hands Here |
|
Pull in this Direction |
|
Protective Tape |
Place your hand at the location shown in the illustration and pull the rear combination light assembly LH toward the rear of the vehicle to detach the pin and guide to remove it.
Pull the rear combination light assembly LH straight towards the rear of the vehicle to prevent the guide from becoming damaged.