73960A
1.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
|
Slowly Pull |
Attach the hook on the side of the airbag door facing the rear of the vehicle and set the instrument panel passenger airbag assembly onto the airbag door.
Slowly pull the instrument panel passenger airbag assembly in the direction indicated by the arrow shown in the illustration to attach the hook on the side of the airbag door facing the rear of the vehicle and install the instrument panel passenger airbag assembly.
Install the 2 screws.
| *a | Connector Lock |
|
Push in this Direction |
Attach the wire harness clamp.
Connect the airbag connector and push the connector lock.
When connecting any airbag connector, take care not to damage the airbag wire harness.
2.INSTALL UPPER INSTRUMENT PANEL
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.PERFORM DIAGNOSTIC SYSTEM CHECK
5.CHECK SRS WARNING LIGHT