Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY
RM3270E _58 Vehicle Interior _041710 SUPPLEMENTAL RESTRAINT SYSTEMS _0199692 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 62170A 1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.

Attach the clip to set the curtain shield airbag assembly RH in place.


d.

Temporarily install the 2 new bolts.


e.

Install the clip.

HINT:

Use the same procedure for the other clip.


i.

Attach the claw to connect a new clip.

NOTICE:

At this time, do not push in the pin to lock the clip.



ii.

Check that the deployment portion of the curtain shield airbag assembly RH is not twisted.


iii.
B407342C01
1.802,0.604 2.25,0.604 true 2.313,0.5 2.625,0.656 0.313,0.156 10 false *a
*a Pin
V113147

Push in this Direction


Push in the pin to lock the clip.


iv.

Lightly pull on the clip to check whether it is locked.



f.

Tighten the 2 bolts in the order shown in the illustration.

Torque:
10.7 N*m (109 kgf*cm, 8 ft.*lbf)

B409193N01
3.073,1.594 3.292,1.823 0.219,0.229 10 true (1) 3.375,1.594 3.594,1.823 0.219,0.229 10 true (2)


g.
B409192C01
1.875,0.365 2.219,0.74 true 1.708,0.24 2.021,0.396 0.313,0.156 10 false *a
*a Connector Lock
V113147

Push in this Direction


Connect the airbag connector and push the connector lock.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.



Hide 2.INSTALL ROOF HEADLINING ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION