Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.
Replace any other damaged parts as necessary.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
73910A
1.INSTALL FRONT SEAT AIRBAG ASSEMBLY RH
Install the front seat airbag assembly RH with 2 new nuts.
The nuts must not be reused.
Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.
Attach the wire harness clamp.
Be careful not to damage the airbag wire harness.
2.INSTALL SEATBACK COVER WITH PAD
71931
3.INSTALL FRONT SEAT HEADREST SUPPORT
71759C
4.INSTALL FRONT NO. 1 SEATBACK HOOK
5.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH
71861
6.INSTALL FRONT SEAT INNER CUSHION SHIELD RH
71811D
7.INSTALL FRONT SEAT CUSHION SHIELD RH
71867A
8.INSTALL FRONT SEAT INNER NO. 1 CUSHION SHIELD RH
9.INSTALL FRONT SEAT ASSEMBLY
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
11.PERFORM DIAGNOSTIC SYSTEM CHECK
12.CHECK SRS WARNING LIGHT