The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the door side airbag sensor removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67491A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH
74210
4.REMOVE FRONT ARMREST ASSEMBLY RH
5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
69283
7.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH
67601
8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH
89865
9.REMOVE DOOR SIDE AIRBAG SENSOR RH
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the door side airbag sensor RH. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push down the housing lock and slide the CPA. (At this time, the airbag connector cannot be disconnected yet.)
| *a | Housing Lock | *b | CPA |
| *c | CPA Upper Part | - | - |
Push down the housing lock again and disconnect the airbag connector.
Do not push down the upper part of the CPA shown in the illustration when disconnecting the airbag connector.
Remove the bolt.
Loosen the bolt while holding the door side airbag sensor RH because the door side airbag sensor RH guide is easily damaged.
If the door side airbag sensor RH has been dropped, replace it with a new one.
Detach the guide and remove the door side airbag sensor RH.