Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
1.PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
45100
3.REMOVE STEERING WHEEL ASSEMBLY
45287
4.REMOVE STEERING COLUMN LOWER COVER
Remove the 3 screws.
|
Place Hands Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Detach the 2 claws and 6 guides to remove the steering column lower cover.
45286B
5.REMOVE STEERING COLUMN UPPER COVER
|
Remove in this Direction |
Detach the 2 claws and 2 guides to remove the steering column upper cover.
6.REMOVE COMBINATION SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY
Disconnect the connectors from the combination switch assembly with spiral cable sub-assembly.
|
Remove in this Direction |
Detach the 3 claws. Remove the combination switch assembly with spiral cable sub-assembly from the steering column sub-assembly.
73900
7.REMOVE NO. 1 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY
45219
8.DISCONNECT STEERING SLIDING YOKE
45025D
9.REMOVE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Remove the 3 bolts and No. 1 steering column hole cover sub-assembly.
45250
10.REMOVE STEERING COLUMN ASSEMBLY
Remove the bolt and 2 nuts, and then pull out the steering column assembly together with the steering sliding with coupling yoke.