The ECM turns on the SET indicator light by sending indicator output demand signals to the combination meter assembly using CAN communication.
The cruise control SET indicator light illuminates when the cruise control system is controlling vehicle speed.
The cruise control indicator light circuit uses CAN communication. If the cruise control indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
When replacing the combination meter assembly, make sure to replace it with a new one.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
According to the display on the GTS, perform the Active Test.
for TFT Display Type:
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Meter Display 1 | Multi-information display | OFF or All | - |
| Tester Display |
|---|
| Meter Display 1 |
The multi-information display in the combination meter assembly turns off or completely on according to the GTS operation
except TFT Display Type:
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Indicat. SET | SET indicator light | OFF or ON | - |
| Tester Display |
|---|
| Indicat. SET |
Cruise control SET indicator light turns ON/OFF
| Result | Proceed to |
|---|---|
| OK | A |
| NG | B |
A
B
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Enter the following menus: Powertrain / Cruise Control / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| SET/COAST Switch | -SET switch signal | ON or OFF | ON: -SET switch on
OFF: -SET switch off |
- |
| Tester Display |
|---|
| SET/COAST Switch |
When the cruise control main switch (-SET switch) is operated, the display changes as shown above.
| Result | Proceed to |
|---|---|
| The indicator operates normally according to the on and off operations | A |
| The GTS screen display changes from off to on, but the cruise control SET indicator light in the combination meter assembly does not illuminate | B |
| The cruise control SET indicator light in the combination meter assembly does not illuminate, and the indication in the GTS screen display stays at OFF | C |
A
B
C