Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2015.08–2016.01
RM3270E _58 Vehicle Interior _041708 METER / GAUGE / DISPLAY _0203147 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Speedometer Malfunction  


DESCRIPTION

The combination meter assembly receives vehicle speed signals from the brake actuator assembly (skid control ECU) via the CAN communication line. The wheel speed sensors output voltages that vary according to the vehicle speed. The brake actuator assembly (skid control ECU) supplies power to the wheel speed sensors. The brake actuator assembly (skid control ECU) calculates the vehicle speed based on the pulses of the voltage.

WIRING DIAGRAM

E255800E13
4.771,2.563 6.99,2.813 2.219,0.25 10 false Combination Meter Assembly 1.146,2.552 2.813,2.99 1.667,0.438 10 false Brake Actuator Assembly (Skid Control ECU) 0.802,3.375 3.563,3.656 2.76,0.281 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the combination meter assembly, make sure to replace it with a new one.

·

If the vehicle speed is outside the allowable range when tested, perform the operation check.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>OPERATION CHECK



HINT:

Before starting the following inspection, check tire size and tire air pressure.


PROCEDURE

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)

Result:
Result
OK
NG



OK

2.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)

NG

2.CHECK FOR DTC (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

3.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION)

NG

3.PERFORM ACTIVE TEST USING GTS (SPEED METER OPERATION)
a.

Using the GTS, perform the Active Test.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Speed Meter Operation Speedometer OFF, 0, 40, 80, 120 or 160 (km/h) There is a deviation in the values displayed on the speedometer display (Control range → Speedometer)
for TFT Display Type:
·

40 → 40.9 to 45.4

·

80 → 81.9 to 86.9

·

120 → 122.8 to 127.8

·

160 → 163.8 to 168.8


for Dot Display Type:
·

40 → 40.5 to 45.0

·

80 → 81.0 to 86.0

·

120 → 121.4 to 126.4

·

160 → 161.9 to 166.9


Body Electrical > Combination Meter > Active Test
Tester Display
Speed Meter Operation
50004 122 1
OK:

Speedometer indication is normal.



Result:
Proceed to
OK
NG



OK

4.READ VALUE USING GTS (VEHICLE SPEED METER)

NG

REPLACE COMBINATION METER ASSEMBLY

4.READ VALUE USING GTS (VEHICLE SPEED METER)
a.

Using the GTS, read the Data List.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost the same as actual vehicle speed -
Body Electrical > Combination Meter > Data List
Tester Display
Vehicle Speed Meter
50003 122 8
HINT:
·

When the Data List values of the ECUs match, an internal malfunction of the combination meter assembly is suspected.

·

When the Data List values of the ECUs do not match, a signal output error of the brake actuator assembly (skid control ECU) or an internal malfunction of the combination meter assembly is suspected.



OK:

Vehicle speed displayed on the GTS is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

5.READ VALUE USING GTS (VEHICLE SPEED)
5.READ VALUE USING GTS (VEHICLE SPEED)
a.

Using the GTS, read the Data List.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Normal Condition Reference Value Diagnostic Note
Vehicle Speed Vehicle speed Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost the same as actual vehicle speed -
Chassis > ABS/VSC/TRC > Data List
Tester Display
Vehicle Speed
50003 105 42
OK:

Vehicle speed displayed on the GTS is almost the same as the actual vehicle speed measured using a speedometer tester (calibrated chassis dynamometer).



Result:
Result
OK
NG



OK

6.CHECK COMBINATION METER ASSEMBLY

NG

REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)

6.CHECK COMBINATION METER ASSEMBLY
a.

Replace the combination meter assembly with a new one.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL


b.

Check that the operation of the speedometer returns to normal.

OK:

The operation of the speedometer returns to normal.



Result:
Result
OK
NG



OK

END (COMBINATION METER ASSEMBLY IS DEFECTIVE)

NG

REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)