In this circuit, the combination meter assembly receives engine speed signals from the ECM via the CAN communication system. The combination meter assembly displays the engine speed calculated based on the data received from the ECM.
When replacing the combination meter assembly, make sure to replace it with a new one.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Check for DTCs.
No DTCs are output.
| Result |
|---|
| OK |
| NG |
OK
NG
Check for DTCs.
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>DTC CHECK / CLEAR
No DTCs are output.
| Result |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>HOW TO PROCEED WITH TROUBLESHOOTING
Using the GTS, perform the Active Test.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| TachoMeter Operation | Tachometer | OFF, 0, 1000, 2000, 3000, 4000 or 5000 (rpm) | - |
| Tester Display |
|---|
| TachoMeter Operation |
Tachometer indication is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Using the GTS, read the Data List.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST
| Tester Display | Measurement Item | Normal Condition | Reference Value | Diagnostic Note |
|---|---|---|---|---|
| Engine Speed | Engine speed | Min.: 0 rpm, Max.: 16383 rpm | Actual engine speed | - |
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Engine Rpm | Engine speed | Min.: 0 rpm, Max.: 12750 rpm | Actual engine speed | - |
| Tester Display |
|---|
| Engine Speed |
| Tester Display |
|---|
| Engine Rpm |
When the Data List values of the ECUs match, an internal malfunction of the ECM is suspected.
When the Data List values of the ECUs do not match, a signal output error of the ECM or an internal malfunction of the combination meter assembly is suspected.
The Data List values of the ECUs do not match.
| Result |
|---|
| OK |
| NG |
OK
NG
Replace the combination meter assembly with a new one.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Check that the operation of the tachometer returns to normal.
The operation of the tachometer returns to normal.
| Result |
|---|
| OK |
| NG |
OK
NG