Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER
RM3270E _56 Audio / Visual / Telematics _041699 AUDIO / VIDEO _0203170 REAR DOOR SPEAKER A

AUDIO / VIDEO  REAR DOOR SPEAKER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 86160B 1.INSTALL REAR SPEAKER ASSEMBLY

a.

Install a nose piece to an air riveter or hand riveter. Then insert the mandrel part of a new φ4 mm waterproof rivet into the nose piece.


b.
E317328

Using an air riveter or hand riveter, install the rear speaker assembly with 3 new rivets.

NOTICE:
·
B171664C17
1.229,1.104 1.083,1.635 1.083,1.635 1.24,2.198 false 1.083,1.635 0.813,1.635 false 1.792,0.896 2.031,1.635 2.031,1.635 1.771,2.531 false 2.031,1.635 2.313,1.635 false 2.26,0.604 2.521,0.802 0.26,0.198 10 *a 2.26,2.448 2.563,2.677 0.302,0.229 10 *b 2.344,1.563 2.594,1.781 0.25,0.219 10 *1 0.594,1.573 0.844,1.75 0.25,0.177 10 *2
*a INCORRECT
*b CORRECT
*1 Mandrel
*2 Riveter


Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

·
B172390C19
0.719,0.115 1.021,0.115 false 0.813,1.146 1.01,1.146 false 0.813,2.438 1.01,2.438 false 2.313,0.573 2.542,0.781 0.229,0.208 10 false *a 2.313,2.76 2.552,2.958 0.24,0.198 10 false *b 1.052,2.365 1.313,2.583 0.26,0.219 10 false *1 2.323,1.573 2.583,1.781 0.26,0.208 10 false *a 1.052,1.073 1.292,1.25 0.24,0.177 10 false *1 1.042,0.031 1.292,0.229 0.25,0.198 10 false *1
*a INCORRECT
*b CORRECT
*1 Riveter


Confirm that the rivets are seated properly against the speaker.

·

Do not tilt the riveter when installing the rivet to the speaker.

·

Do not leave any space between the rivet head and speaker.

·
B172391C18
0.74,0.646 0.938,0.646 false 0.729,2.156 0.938,2.156 false 2.292,1.042 2.615,1.271 0.323,0.229 10 *a 2.302,2.458 2.625,2.667 0.323,0.208 10 *b 0.958,0.552 1.229,0.719 0.271,0.167 10 *1 0.958,2.073 1.271,2.24 0.313,0.167 10 *1
*a INCORRECT
*b CORRECT
*1 Riveter


Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.




c.

Connect the connector.


Hide 67603 2.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY RH

Hide 69283A 3.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG RH

Hide 4.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 74250 5.INSTALL REAR ARMREST ASSEMBLY RH

Hide 67673A 6.INSTALL REAR DOOR FRAME GARNISH RH

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).