The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
63310
3.REMOVE ROOF HEADLINING ASSEMBLY
86300B
4.REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY
Disconnect the connector.
Remove the bolt and then remove the washer and holder.
Remove the No. 1 amplifier antenna assembly of the vehicle outside.
86077
5.REMOVE ANTENNA COVER KIT
Detach the claws and guides and remove the No. 1 amplifier antenna assembly as indicated by the arrows in the order shown in the illustration.
When reusing the No. 1 amplifier antenna assembly:
Remove the seal.