A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
67837L
1.INSTALL DOOR DUST PROOF SEAL
Attach the claw and install 3 new door dust proof seals.
67293A
2.INSTALL BACK DOOR STOPPER CUSHION
Attach the claw to install a new back door stopper cushion.
Use the same procedure as for the RH side.
67281F
3.INSTALL LOWER BACK DOOR STOPPER
Attach the guide to install the lower back door stopper with the bolt.
Use the same procedure as for the RH side.
85110R
4.INSTALL REAR WIPER MOTOR ASSEMBLY
69350
5.INSTALL BACK DOOR LOCK ASSEMBLY (w/ Power Back Door)
69350
6.INSTALL BACK DOOR LOCK ASSEMBLY (w/o Power Back Door)
89747E
7.INSTALL POWER BACK DOOR WARNING BUZZER (w/ Power Back Door)
89222A
8.INSTALL MULTIPLEX NETWORK DOOR ECU (w/ Power Back Door)
86790D
9.INSTALL REAR TELEVISION CAMERA ASSEMBLY (w/ Parking Assist Monitor System)
81690A
10.INSTALL LICENSE PLATE LIGHT ASSEMBLY LH
81270D
11.INSTALL LICENSE PLATE LIGHT ASSEMBLY RH
84840G
12.INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
76801
13.INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
81590A
14.INSTALL REAR LIGHT ASSEMBLY LH
81580A
15.INSTALL REAR LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
899A0A
16.INSTALL NO. 2 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Entry and Start System)
67290
17.INSTALL BACK DOOR DAMPER ASSEMBLY
Attach the guide.
Install the back door damper assembly with the 3 bolts.
85345R
18.INSTALL REAR WASHER NOZZLE
19.INSTALL REAR SPOILER ASSEMBLY
64886B
20.INSTALL BACK DOOR GLASS CHANNEL LH
64885C
21.INSTALL BACK DOOR GLASS CHANNEL RH
Use the same procedure as for the LH side.
84280D
22.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door)
84270G
23.INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door)
Use the same procedure as for the LH side.
67750
24.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Attach the clip to install the back door trim board assembly.
84931C
25.INSTALL BACK DOOR CONTROL SWITCH (w/ Power Back Door)
55539
26.INSTALL SPARE SWITCH HOLE COVER (w/o Power Back Door)
Attach the claw to install the spare switch hole cover.
74811D
27.INSTALL DOOR PULL HANDLE
w/ Power Back Door:
Connect the connector.
Attach the claw to install the door pull handle.
67938A
28.INSTALL BACK DOOR SIDE GARNISH LH
Attach the claw and clip to install the back door side garnish LH.
67937B
29.INSTALL BACK DOOR SIDE GARNISH RH
Use the same procedure as for the LH side.
67939B
30.INSTALL CENTER BACK DOOR GARNISH
Attach the claw and clip to install the center back door garnish.
85143R
31.INSTALL REAR WIPER MOTOR GROMMET
32.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
85292A
33.INSTALL REAR WIPER ARM HEAD CAP
34.INSPECT POWER BACK DOOR SYSTEM (w/ Power Back Door)