Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
68920
1.INSTALL POWER BACK DOOR UNIT ASSEMBLY SET LH
Clean the threaded portion on the vehicle body with non-residue solvent.
for Back Door Side:
Temporarily install the power back door unit assembly set LH.
Tighten 2 new bolts to install the power back door unit assembly set LH.
Tighten the bolts in the order shown in the illustration.
Install the power back door unit assembly set LH while supporting the back door by hand.
Check that the power back door unit assembly set LH is engaged in the ball joint and that the back door unit assembly cannot be pulled out.
for Body Side:
Temporarily install the power back door unit assembly set LH.
Tighten 2 new bolts to install the power back door unit assembly set LH.
Tighten the bolts in the order shown in the illustration.
Install the power back door unit assembly set LH while supporting the back door by hand.
Check that the power back door unit assembly set LH is engaged in the ball joint and that the back door unit assembly cannot be pulled out.
Attach the grommet.
Connect the connector.
84280D
2.INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH
67750
3.INSTALL BACK DOOR TRIM BOARD ASSEMBLY
74811D
4.INSTALL DOOR PULL HANDLE
67938A
5.INSTALL BACK DOOR SIDE GARNISH LH
67937B
6.INSTALL BACK DOOR SIDE GARNISH RH
67939B
7.INSTALL CENTER BACK DOOR GARNISH