The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door lock removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
Fully open the front door glass sub-assembly RH before proceeding with work.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67491A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH
74210
4.REMOVE FRONT ARMREST ASSEMBLY RH
5.REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
69283
7.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH
67601
8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH
67831
9.REMOVE FRONT DOOR SERVICE HOLE COVER RH
68141C
10.REMOVE FRONT DOOR GLASS RUN RH
68101
11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY RH
67403F
12.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY RH
13.REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)
69310
14.REMOVE FRONT DOOR LOCK ASSEMBLY RH
|
"Torx" Screw |
|
Connector |
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
| *1 | front door lock open rod RH |
|
Remove in this Direction |
Disconnect the front door lock open rod RH and remove the front door lock assembly RH as shown in the illustration.
69035A
15.REMOVE FRONT DOOR LOCK COVER SUB-ASSEMBLY RH
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and clamp and remove the front door lock cover sub-assembly RH from the front door lock assembly RH.
Tape the thin-bladed screwdriver tip before use.
69750C
16.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY RH
|
Remove in this Direction |
Detach the guide and remove the front door inside locking cable assembly RH from the front door lock assembly RH.
69710B
17.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY RH
|
Remove in this Direction |
Detach the guide and remove the front door lock remote cable assembly RH from the front door lock assembly RH.
69318C
18.REMOVE DOOR LOCK WIRING HARNESS SEAL
|
Remove in this Direction |
Remove the door lock wiring harness seal from the front door lock assembly RH.