The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door lock removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
Fully open the rear door glass sub-assembly RH before proceeding with work.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67673A
3.REMOVE REAR DOOR FRAME GARNISH RH
74250
4.REMOVE REAR ARMREST ASSEMBLY RH
5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
69283A
6.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG RH
67603
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH
67841E
8.REMOVE REAR DOOR SERVICE HOLE COVER RH
68142C
9.REMOVE REAR DOOR GLASS RUN RH
67407E
10.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY RH
68103
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY RH
67836
12.REMOVE REAR DOOR LOCK CHILD PROTECTION COVER RH
69330
13.REMOVE REAR DOOR LOCK ASSEMBLY RH
| *a | Release Plate |
|
"Torx" Screw |
|
Connector |
|
Remove in this Direction |
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Slide the rear door lock assembly RH downward, and pull the release plate out of the rear door outside handle frame sub-assembly RH.
69037
14.REMOVE REAR DOOR LOCK COVER SUB-ASSEMBLY RH
|
Protective Tape |
Using a thin-bladed screwdriver, detach the claw and clamp and remove the rear door lock cover sub-assembly RH from the rear door lock assembly RH.
Tape the thin-bladed screwdriver tip before use.
69730D
15.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY RH
|
Remove in this Direction |
Detach the guide and remove the rear door lock remote control cable assembly RH from the rear door lock assembly RH.
69770B
16.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY RH
|
Remove in this Direction |
Detach the guide and remove the rear door inside locking cable assembly RH from the rear door lock assembly RH.
69318D
17.REMOVE DOOR LOCK WIRING HARNESS SEAL
Remove the door lock wiring harness seal from the rear door lock assembly RH.