Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM3270E _59 Vehicle Exterior _041716 WINDOW / GLASS _0206018 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.

·

A bolt without a torque specification is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 85710F 1.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

a.

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.
B405914

w/ Jam Protection Function:

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly RH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new power window regulator motor assembly RH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



c.
B430662

w/o Jam Protection Function:

Using a T25 "TORX" socket wrench, install the power window regulator motor assembly RH with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new power window regulator motor assembly RH uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69803 2.INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY RH

Hide 68103 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY RH

Hide 67407E 4.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY RH

Hide 68142C 5.INSTALL REAR DOOR GLASS RUN RH

Hide 67841E 6.INSTALL REAR DOOR SERVICE HOLE COVER RH

Hide 67603 7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY RH

Hide 69283A 8.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG RH

Hide 9.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 74250 10.INSTALL REAR ARMREST ASSEMBLY RH

Hide 67673A 11.INSTALL REAR DOOR FRAME GARNISH RH

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION