Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR(for Rear Door)
RM3270E _59 Vehicle Exterior _041716 WINDOW / GLASS _0206018 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power window regulator motor disassembly/reassembly are shown below.

Necessary Procedures after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal w/ Power Back Door System:
Reset back door close position
Power back door system (Click here)

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.

·

Fully open the rear door glass sub-assembly RH before proceeding with work.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67673A 3.REMOVE REAR DOOR FRAME GARNISH RH

Hide 74250 4.REMOVE REAR ARMREST ASSEMBLY RH

Hide 5.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69283A 6.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG RH

Hide 67603 7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH

Hide 67841E 8.REMOVE REAR DOOR SERVICE HOLE COVER RH

Hide 68142C 9.REMOVE REAR DOOR GLASS RUN RH

Hide 67407E 10.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY RH

Hide 68103 11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY RH

Hide 69803 12.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY RH

Hide 85710F 13.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

a.
B405914

w/ Jam Protection Function:

Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly RH.


b.
B430662

w/o Jam Protection Function:

Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly RH.