Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › DOWNHILL ASSIST CONTROL SWITCH
RM3270E _54 Brake _041691 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0217085 DOWNHILL ASSIST CONTROL SWITCH A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  DOWNHILL ASSIST CONTROL SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55667 3.REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH

Hide 55011A 4.REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55012A 5.REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 33504F 6.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 58808 7.REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Automatic Transmission)

Hide 58804A 8.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 55405B 9.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 55407C 10.REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY

Hide 84988H 11.REMOVE DOWNHILL ASSIST CONTROL SWITCH

a.
C329863C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the downhill assist control switch connector.


b.

Detach the 2 claws and remove the downhill assist control switch from the lower instrument cover sub-assembly.