Home › Engine / Hybrid System › 5L-E ENGINE MECHANICAL › ENGINE UNIT › from 2016.01
RM3270E _51 Engine / Hybrid System _048650 5L-E ENGINE MECHANICAL _0231141 ENGINE UNIT A

5L-E ENGINE MECHANICAL  ENGINE UNIT  REASSEMBLY  


PROCEDURE

Hide 11381A 1.INSTALL REAR CRANKSHAFT OIL SEAL

a.
A057639E03
1.417,1.448 0.792,0.719 0.792,0.719 1.604,1 true 0.427,0.604 0.75,0.854 0.323,0.25 10 false SST

Using SST and a hammer, tap in a new rear crankshaft oil seal until its surface is flush with the rear crankshaft oil seal retainer edge.

SST
09223-15030  
09950-70010  (09951-07100)


b.

Apply MP grease to the lip of the rear crankshaft oil seal.


Hide 11381 2.INSTALL REAR CRANKSHAFT OIL SEAL RETAINER

a.

Install a new gasket and the rear crankshaft oil seal retainer with the 4 bolts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 11301 4.INSTALL TIMING BELT CASE SUB-ASSEMBLY

Hide 15104 5.INSTALL OIL STRAINER SUB-ASSEMBLY

Hide 12101 6.INSTALL OIL PAN SUB-ASSEMBLY

Hide 13505 7.INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

Hide 16100 8.INSTALL ENGINE WATER PUMP ASSEMBLY

Hide 13502 9.INSTALL NO. 2 TIMING BELT IDLER SUB-ASSEMBLY

a.

Install the spacer and No. 2 timing belt idler sub-assembly with the bolt.

Torque:
33 N*m (337 kgf*cm, 24 ft.*lbf)


b.

Check that the No. 2 timing belt idler sub-assembly moves smoothly.


Hide 11101 11.INSTALL CYLINDER HEAD SUB-ASSEMBLY

Hide 11305A 13.INSTALL CAMSHAFT OIL SEAL

Hide 11385 14.INSTALL CAMSHAFT OIL SEAL RETAINER

Hide 11201 15.INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY

a.

Clean and degrease the contact surfaces of the cylinder head cover sub-assembly and cylinder head sub-assembly.


b.
A056814C02
0.406,1.927 0.656,2.104 0.25,0.177 10 false *a
*a Seal Packing


Apply seal packing to the specific areas shown in the illustration.

Seal packing:

Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent


NOTICE:
·

Remove any oil from the contact surface.

·

Install the cylinder head cover sub-assembly within 3 minutes after applying seal packing.

·

Do not start the engine for at least 2 hours after installing the seal packing.




c.

Install a new cylinder head cover gasket and the cylinder head cover sub-assembly to the cylinder head sub-assembly with the 9 bolts and nut.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


Hide 12108 16.INSTALL OIL FILLER CAP SUB-ASSEMBLY

Hide 11322B 17.INSTALL NO. 2 TIMING BELT COVER

Hide 13523P 18.INSTALL CAMSHAFT TIMING PULLEY