Home › Engine / Hybrid System › 5L-E COOLING › WATER PUMP › from 2016.01
RM3270E _51 Engine / Hybrid System _048955 5L-E COOLING _0237586 WATER PUMP A

5L-E COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of timing belt Mode reset operation
·

Does not illuminate when replacement is necessary

·

Illuminates when replacement is not necessary


(Click here)

CAUTION:
A343701

Do not remove the radiator cap sub-assembly, cylinder block water drain cock plug or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 16571C 3.REMOVE NO. 1 RADIATOR HOSE

Hide 44360 4.DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY

Hide 44369A 5.REMOVE OIL RESERVOIR BRACKET

Hide 16470 6.REMOVE RADIATOR RESERVOIR

Hide 16711 7.REMOVE FAN SHROUD

Hide 16100 9.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A031001

Remove the 6 bolts and tension spring bracket.


b.

Remove the engine water pump assembly and gasket.