1.REMOVE MANUAL TRANSMISSION ASSEMBLY
31230
2.REMOVE CLUTCH RELEASE BEARING ASSEMBLY
31236B
3.REMOVE RELEASE FORK SUPPORT
31111
4.REMOVE CLUTCH HOUSING
33131D
5.REMOVE FRONT BEARING RETAINER
33124C
6.REMOVE NO. 1 OIL RECEIVER PIPE
33131A
7.REMOVE FRONT TRANSMISSION BEARING RETAINER OIL SEAL
| *a | Protective Tape |
Using a screwdriver, pry out the front transmission bearing retainer oil seal.
Be careful not to damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.
Tape the screwdriver tip before use.
33131A
8.INSTALL FRONT TRANSMISSION BEARING RETAINER OIL SEAL
Using SST and a press, press in a new front transmission bearing retainer oil seal.
0.8 to 1.8 mm (0.0315 to 0.0708 in.)
Apply MP grease oil to the lip of the front transmission bearing retainer oil seal.
33124C
9.INSTALL NO. 1 OIL RECEIVER PIPE
33131D
10.INSTALL FRONT BEARING RETAINER
31111
11.INSTALL CLUTCH HOUSING
31236B
12.INSTALL RELEASE FORK SUPPORT
31230
13.INSTALL CLUTCH RELEASE BEARING ASSEMBLY
14.INSTALL MANUAL TRANSMISSION ASSEMBLY